Pneumatic Speed Controller

Product Introduction

These push-to-connect flow control valves (speed controllers) provide accurate flow regulation for precise speed control of pneumatic cylinders. For best performance, plumb elbow-meter-in style valves directly into cylinder ports. Use two valves to control extension and retraction speeds separately. Elbow-meter-out and inline flow control valves also available.

• 100% raw material testing

• 100% testing before shipping

• PBT bodies & Nickel-plated brass thread

• Polyacetal push buttons

• Stainless steel grab rings which grips the tubing to provide retention

• Swivels featured on all male pipe threaded shapes (not to be used for live swivel applications)

• BSPT and NPT thread coming with a pre-applied white acrylic sealant

• BSPP thread coming with O-ring

Assembly Instructions

1. Cut thermoplastic tubing squarely. Be certain the port or mating part is clean and free of debris.

2. Insert tubing into fitting until it bottoms. A slight twisting motion will ease the insertion. Pull on tubing to verify it is properly retained in the fitting.

3. To disassemble, simply push the release button against the body and remove tubing.

4. It is recommended to trim the tubing after every disassembly to insure a proper seal.

Specification